Ryobi no longer makes a fence which directly works with this router. This DeWalt model fits very well onto my Ryobi RE180PL1 router. Hope this helps any other questions feel free to ask. Some woodworkers would call this a parallel fence. and you want to secure your work piece safely down to your bench or work surface. One thing to note this is a cut that should take several passes to achieve, don't try and tackle this with one cut it should take several. Then with the router turned on lower your bit and make your first cut, as you move the jig it will pivot from the point it is screwed down at. Line up that hole with the pencil mark you made to locate the center of your circle and attach the jig with a screw directly through this hole into the material you are creating the cut in, the screw should be tight enough to hold the jig in place but allow the jig to rotate. The size of the circle is determined by the distance between the router bit and the corresponding hole with in the series of holes you drilled. Straight guide with fine fence adjuster for precision positioning of the. Then place the jig with the router attached on top of the material you marked for the circle cut. Edge Guide with Dust Collection for DEWALT Routers (for DW610, DW616, DW618. The way this works is locate the center of the circle you wish to create and mark it with a pencil. Then drill a hole about every 1/4 of an inch over the length of this pencil line, this hole should be just large enough to except a small screw. Instead you would draw one pencil line center of the base that goes from the opening for the router bit to the opposite end of the jig. Here is how you want to do this, build the base of the jig as I did but do not create the slots or build the fence. A circle cutting jig is basically built the same as this jig.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |